Did my first pull using cybs ATB TEK followed all the steps and the end product looks fine however I still feel kind of wary to use it. So I was wondering if there is some testing I can do to make sure that it is only dmt. I can't smell any solvents anymore but the smell of the product may be overpowering and I have never used or had dmt so I'm not sure if the smell is correct.

It smells like rubber/plastic like new pair of shoes or mothballs.

Simply just re-x it and try it out. I dont see any reason why you would be scared if you made it.

What is your concern? leftover solvent or lye or what? (TThat's often times over exaggeration)

Even if its not only DMT, you can bet its mostly DMT 95%+ you've might pulled other present plant alkaloids or fats/oil but that wont hurt you.

Good Luck

Yeah I'm a bit worried about the lye I'm not so worried about solvent since I can't smell it at all.

If you're worried about lye, recrystallise.

If there weren't any blobs of base soup in your freeze precipitation dish this shouldn't be an issue.

Good quality DMT has a faint, sweet, floral/bubblegum odour.

for some reason a jar of peanut butter comes to mind


in all seriousness, what was already suggested is stellar

Purely for some simple testing see below.

Thiele tube + sample in a capillary + thermometer + burner and check melting temp.
ph strip to check for NaOH
Marquis reagent and DMT comes out orange
Flame test will be yellow in presence of sodium

If you're really worried about NaOH then simply re-x as already suggested. It should not be a major issue anyways as NaOH solubility in common hydrocarbons is minimal at best.