Hi, I recently did my first AC extraction using a newbie Straight-to-base tech and mostly everything went well
Problem is a few things still posed an obstacle.
The first one was when I was performing the defat - When I mixed and 200ml naptha with the powdered bark to defat the AC solution and agitated it, a LOT of foam had formed in the container. After about 30 minutes most of this foam had dispersed but there was still a little leftover, making it a little bit difficult to be sure all of the naptha was totally pythoned out.
Also, when pythoning out the DMT-rich NPS from the solution, and I'm attempting to suck up the very last bits I always get a little bit of the AC solution in my extracted NPS. Then when I freeze my NPS to crystallize the DMT, this is always left over residually at the bottom. Is there a quick way to remove this, or a way to prevent it from being pulled with the NPS in the first place?
Everything said by this profile is fictional and not to be taken as fact.