so Ive been using a version of noman's that I modified after some very successful experimentation. It wasnt until I made further modifications that I began to run into some trouble and even then it wasnt until the very end. So what I figured Id do is explain my original modified version of the tek and then explain the new modifications and the issue I encountered.

noman's tek (draped up and dripped out kno what Im talkin bout??)

(I use pre powdered root bark so I cant take credit for the first modification)
-for every gram of root bark I use 1.5x the amount of water and lye required by the original tek
-Once mixed I allow the MHRB/lye mixture to sit for roughly 8-12 hours, but no longer as a reduction in purity will begin to be observed
-I do 5 pulls using a .75 mls of heated naptha for every one gram of bark used, which are then collected into a single pyrex baking dish.
-I allow the 5 combined pulls to evaporate 1/2 way in front of a fan
-The pyrex is then covered and placed upon a bed of ice in the freezer for 8 hrs.
-Once precipitation has occurred the naptha is poured slowly enough so all floating crystals remain within the pyrex
-I then place the pyrex back into the freezer uncovered for roughly an hour untill I can no longer smell naptha.
-Upon removal I place the pyrex, uncovered, infront of the fan for 15-20 minutes untill dry
-and then I scrape!

My results have always been consistent, clean white product with a minimum return of 1 percent.

Now during my last extraction I decided to break the pulls down into 10 pulls instead of 5 using 130 gs of barks and 50 ml heated naptha for each pull. After draining the naptha I was left with a very promising crispy white product and a nice yield. So I allowed the pyrex to dry in front of the fan. once it was dry I set it on the counter and kinda forgot about it for an hour. when I looked back I noticed that a significant amount had melted into oil. I put it back in the freezer and pulled it out once it looked ok and tried again, only to have it do the same thing. My next step was to dissolve the mushy oil into warm naptha and re freeze. Once I removed the pyrex from the freezer I relaxed. Again I saw a big, all white, yield. Unfortunately, when I went to dry it it began to melt again. The pyrex is back in the freezer as we speak. What should my next step be and why is this happening?

Yes I appreciate that, but not every new member avoids research at all costs. I did everything it said, it seemed like if there was left over solvent then it must have been trapped in the spice somewhere. And not only that, every time I set it out to dry it smelled great, i.e. not like naptha, but strictly dmt. So yea I know you veteran nexusers get a lot of unnecessary questions, but I need a little more help then that offered. I flipped it upside down, dissolved it little by little into as small amount of naptha as possible and still wound up with THE AMAZING DMT DISAPPEARING ACT! AGONIZINGLY UNEXPLAINABLE FOR ALL SHAPES AND SIZES!! come one... come all...

Not trying to be a dick... it was just the last of mhrb and pay day aint till thursday....

What do you mean "leftover solvent"?
You didn't mention that in the first post.
Did you recover significantly less solvent than you used to extract?

The disappearance act has something to do with the freeze precip I think.
I'd just evap and see what comes out.