I re-wrote this Tek (with some minor tweaking)to meet my understanding and flow and just want to make sure that what I'm about to do will work.
There are specific reasons I decided to do the tek this way instead of the normal naphtha version. Mainly I don't have a freezer. Also, even though I'm scientifically minded enough to realize that using conventional chemicals is just as safe as using food grade... I just am in love with the notion of being as natural as possible.
Positive criticism is welcome. Ive had countless Aya experiences and have finally decided its time to smoalk.
Supplies:• 50g MHRB
• 50ml 5% white vinegar
• Large glass container
• Distilled water
• Wood chop stick or something similar to stir
• 50g lime
• 375-500ml d-limonene
• HDPE2 milk jug
• 2 funnels
• Cotton balls
• 2 mason jars
• fumaric acid
• sodium carbonate
TEK1. Place 50g MHRB large glass container
2. Add roughly 50ml 5% white vinegar to container until most of bark is wet, red, and clumpy
3. While stirring, slowly add about 50ml of near boiling distilled water. Add until it is wet enough to allow for flow when the container is tipped from one side to another. The bark will absorb some of the water the first few minutes. Add more warm/hot water to get it wet enough again as needed.
4. Stir several times as the bark is left to sit for 45 minutes (stir periodically)
5. Add 40g-50g lime to mix bit by bit and mix in well.
6. Add water (if needed) to make the mix look anywhere from thick oatmeal to a thick pea soup.
a. If too dry add water (small amount at a time)
b. If too wet add lime
7. Add 75-100ml d-limonene
8. Stir or roll periodically over next 24 hours
9. Pour solvent from bark into HDPE2 milk jug through a funnel with a cotton ball. You needn't be too fussy about getting 100% of the solvent. Pouring usually gets 90% or more.
10. Repeat steps 7-9 at 2 days 4 days 7 days and 14 days.
11. Fill a mason glass jar with water and add a teaspoon of fumaric acid to it while mixing strongly for a minute or two. Add more slowly until undissolved material falls to the bottom.
12. Decant this jar so only FASW (fumaric acid saturated water) solution is left.
13. Mix limonene pull with FASW solution in a ratio of 5:1 (5 parts limonene to 1 part FASW solution)
14. Mix well and let layers separate and pull FASW out.
15. Repeat steps 15 and 16 2 more times putting all FASW in same container
16. Let FASW evaporate. You now have DMT fumarate which can be taken orally with a MAOI but not smoked.
17. Make a small amount of saturated sodium carbonate solution by adding sodium carbonate to water until no more will dissolve.
18. Decant sodium carbonate saturated solution to remove precipitate
19. Add just enough near boiling water to glass container holding dry dmt fumarate until completely dissolved.
20. Slowly add a small amount of sodium carbonate saturated solution to dmt fumarate solution only a few Ml at a time. Let rest a few minutes and add a few more Ml. Keep adding until no more clouding or color change occurs and then add a little more for good measure. GO SLOW.
21. Put container into fridge for 3-5 days and dmt crystals will precipitate out completely
22. Pour off water though a coffee filter
23. Scrap up dmt from bottom and let dry
24. Smoalk DMT freebase
PS
This is what the alphabet would look like if Q and R were missing