spencer420 wrote: put the sulotion that is in the macin jars in hot hot water, I want to know at what degrees does it need too be at?
how long does it have to sit in the hot water
do you shake in stir when its done boiling or why its boling
how long do you need to stir and shake,
will this disturb the black sluge
and when it comes too doing the shacking stiring what do use such as a utensolor do you just keep the lid on and shake in swish it around
then you abstract the nap off the top with meat syringe and you are then deposting nap into glass container, freeze wait two days and then you filter and then you got good stuff.
as far as hot water (when) i use a hot water bath i just use hot tap water 140F(60c) to 150F(65c)
it will need to sit in the hot water bath untill the liquid in the jar is about as hot as the bath
just wait till its finished warming completely before shaking (shaking trumps stur)
BOIL!! i highly advise against boiling industrial solvents thts bad news
i also advise that you do not use a hot waterbath on your stove again (FLAMES+SOLVENT=FIREDEPARTMENT)
get a dishpan or something
you only need to shake the jar for about 20 seconds let it seporate then shake again - i look for a color change in the solvent to know when i should seporate the solvent from the jar
yes it will disrupt the black slude - the idea of shaking is to mix the solvent with the sludge so the solvent can puckup the goodies
make sure the lid is air tight - as long as you have enough base in your solution shake the hell out of it
correct you would want to place the nap into a second clean glass jar and freeze it for many many hours then filter the crystals (save the nap) dump the filtered nap back into your jar of black sludge and repeat at least 2 more times
hope this helps
as a side note keep in mind if you dont get crystals after freezing you might wanna try to evap 50% of your nap and freeze again
"Oh Dinah. It’s just a rabbit with a waistcoat... and a watch?!"