Ok, so I did a STB on 250g of MHRB and pulled with Xylene.
The xylene pull was really dark brown. (I used a good bit of heat)
I then made up some FASW and at first added it drop wise to the xylene.
It seemed like instead of precipitating anything, it was just kinda blobbing up and falling to the bottom.
So instead of adding it drop wise, I just dumped the remaining FASW solution into the xylene and shook the hell out of it a few times.
Now I have three layers and I'm not sure how to proceed.
The top layer of xylene is very yellow compared to the dark brown it was but still far from clear.
The middle layer seems to be precipitate and the bottom layer is some dirty looking water.
I've included a couple of pics to hopefully help out.
My goal was to end up with clean xylene that I could use again and to have a nice batch of full spectrum fumarates for oral use.
What should I do next to accomplish this?
MelCat attached the following image(s):
100_5351.JPG
(2,596kb) downloaded 202 time(s). 100_5352.JPG
(2,567kb) downloaded 202 time(s).Convert a melodic element into a rhythmic element...