Using a set of digital scales ranging from 0.01g ,am I right in saying that for a 1 dose measurement of spice ,say 50mg it should read 0.05g on the scales?

No.. OP was correct 50mg=0.05 (.5 would be half of a gram which is 500mg) .. just checking, you are aware that this is a massive dose yes? Are you weighing crystals or changa? 15-20 mg is a good dose for most. 50 is going to be a rough ride vaped.

Are you shure its not 0.05 as there are 1000mg in 1 gram

Make sure that what you state is correct before posting!

1g = 1000mg
0.5g = 500mg
0.1g = 100mg
0.05g = 50mg
0.03g = 30mg
0.01g = 10mg
etc...


Kind regards,

The Traveler

I agree..

I would recommend dosing lower than what you want, because the scale you're using is likely inaccurate to at least 5 milligrams.

Maybe weigh out .100 and divide it into quarters. Or better yet weigh out a gram of DMT with a gram of Herb and infuse the herb with DMT , then smoalk like .05 of that effectively delivering a 25mg dose of DMT

My electronic scales

Onefive...what plane of existence are you currently posting from?? hahaha

Onefive- I don't think you are reading your scale right or you have an extremely inefficient smoking method where you are wasting 90% of your dose. I'm guessing it's the scale. A miligram scale is still in grams, just @ finer increments .001 (1mg).. Is your measured pile the size of an eraser head or the size of a quarter?

a quarter.

i deleted my quotes.
this thread looks odd now

Wow..seriously?? May I ask how you are administering such a large dose? That's beyond a human dose.. are you a horse by chance?

haha.
I havnt vaped in months ,since i got into changa.
I'd heat up the copper scourer then pour the dmt onto it ,instantly melting it.
Then id shove it into the mouth of this vinegar bottle .The bottom of the vinegar bottle has a hole drilled into it with a glass tube/pipe stuck through it.
I copied the design of some one here in the nexus.
No wonder my break through was so uncomfortable .

Do you have a trip report anywhere of said breakthru

Glad I asked about the dosage measurement hopefully a lot of people have read this


I was wondering if I were to sandwich the crystals between two pipe screens and then flame it through my MJ water bong would that vape the crystals ok.Check my other thread for a pic of the extraction ..(new uk member planning dmt extraction)

if you are going to do the "sandwich" method, then you will want to put down a bed of herb or ash on a screen or two, then the crystals then another layer of herb on top of that, then barely "lick" the flame to the herb to get a cherry going (don't just roast it like a bowl and torch it) let the cherry do the work. The herb/ash will keep the dmt from simply melting and running down your pipe (which is what can and will most likely happen if you just use screens).

Obviously a GVG or "Machine" will be more efficient when vaping crystals, but if using a bong is what you're after, then either do the herb sandwich or make some infused leaf/changa

Good luck!

*O*