Xtechre's Spice Washing Techre; Ver 1.0.

This technique can be used on Freebase DMT that has been acquired by either A/B, STB or a freebasing of DMT salts such as DMT fumarates.

1. Add drop wise to DMT Naphtha at room temperature, agitating until all DMT is dissolved. This may take some work at room temp, so a kitchen knife may help to stir/break up the DMT, then decant away from any remaining undissolved impurity's. Depending on how dirty the product was initially, some visually detectable impurity's may remain undissolved. These impurity's depend on the starting material, in the case of DMT yielded from FASW this may be excess fumaric acid (just one example). This is your Non Polar Phase.

2. Roughly measure the volume of DMT solution prepared in Step 1... and quadruple it. This is the volume of water you will add a pinch of sodium carbonate to. Literally a pinch. For a gram of DMT this pinch will be small. For 10 grams it might be a little bigger... it really doesn't take much. This is your Aqueous basic phase.

3. Mix the DMT solution (Non Polar Phase) with the Sodium Carbonate solution (Aqueous Basic Phase) with vigor for 3.333 seconds and firmly place upon the table, watch the two layers become visible and separate them mechanically as fast as possible using whatever baster/glass syringe/decanting technique you have mastered in the DMT extraction earlier. Separating these layers (technically phases) quickly is the key here other wise you will experience loss of DMT into the basic aqueous phase.

4. Taking the DMT solvent solution and evaporate it to a volume of 50% or less (till it go's milky when blown upon... this is to make it saturated so that the DMT can precipitate out efficiently when you... put it in the freezer.