Hi fellow travelers

I have a tree who's name is jeanette and she told me that a birch tree was wondering how long the mimosa powder should stay in the base water.He had always had it in for 24 hours to ensure maximum yield.He pulled it then in 2 pulls.the last one giving very little crystals.How long should he wait before he can make a the first pull?

And he told us he heated up the naptha in a waterbath,boiling the water till the naptha was visibly evaporating.Is this a good thing to do,and can it also be used to evaporate 2/3 of the naptha volume before freeze perecipating it?

And the drying issue he was wondering about...He was frustrated he can't the crystals to stay whit when he dries them.Jeanette told him it was problably n,n,oxide.He dries is with the mason jars tilted with a cold fan blowing air in them.Are there other (quick)ways of drying which ensures a white product?

And he really would like some glass shard crystals.Can anyone post a link on a nice pictorial?I've seen them here,i just can find them back

Peace!

Hey I think this is the pictorial you might be looking for.

https://www.dmt-nexus.me...amp;replacenum;post10545

It is a bit of work though and I hear the slightly yellow spice is more potent, not sure if that's true but it has be the case for me.

Swim usually leaves the bark and lye for 24 hours before the first extraction, then continues pulls any time after that. To get more out of his pulls he usually fills the sink up with the hottest water it can produce, adds naphtha to his solution and places the entire container into the water. Leaves the naphtha undisturbed for the first 30mins (apparently it can ruin it if you shake straight away). Then after the 30mins release any pressure in you container shake/mix carefully and leave for 4 hours filling a new bath of hot water every hour. Also every time he refills the water he shakes/mixes a little. He would advise a wash especially if the bark used is from Acacia, with the heat it tends to suck in the oils/fats and make it dirty(well at least in his experience). Swim is still a newb here and the big dogs will be probably be along to give some top advice, but there is what's worked for Swim in many extractions. Good luck.

so trees are doing extractions now? it's amazing how consciousness is evolving on this planet! Though what would be really interesting would be magic mushrooms or cacti trying to extract dmt... now that would be something to see

perhaps you can try to not heat the naphtha during your pulls. it could be that heating it causes more plant-fats to migrate into the naphtha and thus you get yellow product. Also I always try to work with small pulls so I don't need to evaporate any of the solvent before freeze precipitation. I do it this way because I have an aversion against wasting these things.

Concerning your drying tek it sounds like you're doing it right. You can also try what is written in the FAQ - putting it back in the freezer after decanting, upside down, to let the excess solvent drop down, or try the fridge. I'm not sure how necessary this is, it seems to depend on climate. Where I live I just let the air dry it, but my climate is dry and moderate/cool.

check out the wiki for some info on recrystalizations.