Impeccable wrote:Big Inhale wrote:Impeccable wrote:well someone else mentioned the water, I went with 10ml/gram mhrb the recommended amount is 15 thus a deviation by 34% (which I think is significant no?)
Plus I didn't use a lot of naphta and I only had 50g MHRB, combine all this together and I think it makes some sense
for my next attempt (FIFTH TIME! I would've given up by now but I still have 200g MHRB from this source, I can't just through that away) I'm going to get VM & P naphta, it's cheaper, so I'll use much more, and do three different pulls, 25ml 50ml 100ml and see what that gets me.
Plus I'll make the water 15ml / gram mhrb 1.mix 50 Grams lye with 750ml of water.mix thoroughly. 2.add 50 grams powdered mimosa mix thoroughly(shake the fuck out of it)let sit for at least an hour. 3.add 100 ml of naptha(in your case 50ml of ronsonol) shake the hell out of it for at least an hour 4.separate naptha and freeze. If you follow this simple method it will work.You should combine all your ronsonol to get 100 ml. Also you wont have to evap any if you freeze precip your solvent in a flat 9×13 flat pyrex dish. Dont deviate from those numbers.I know that this is irritating but stick with this. When it works you will be satisfied. So beautifully simple, so you do 2 pulls then? How do you mix it and how long for each mix? Don't tell me you shake none stop for an hour. You should do at least three 100ml pulls. Mix the naptha and bark solution by shaking the container it is in.1st pull needs to sit at least an hour second pull at least 24 hours third pull a week. first pull shake every ten minutes for an hour before separating solvent. This spice will be very yellow you will need another solvent for a recrystalization DO NOT SMOKE UNTILL THEN. Can you Imagine? From one single Idea everything appeared here.
RZA
Here in the Prime Creators universe all things are possible,because all things are possible many lessons are learned.
None Of This Is Real!
|
|
|
Big Inhale wrote:acolon_5 wrote:I always have heard that ronsonal evaps dirty. Beacuse of that I've never bothered with it, plus it's a bit expensive compared to hardware store naphtha.
Has someone evaped a decent amount of it (500mL or so) to see what kind of residue it leaves behind? it is dirty very yellow spice. Needs at least one recrystalisation needed in different solvent. I was refering to just the ronsonal. If you evap it straight from the can you will end up with a nasty residue...at least this is what I've heard. Possible rust retardents or other nasties could be lurking in there....again, I've only read this online and have not performed my own tests on it. VM&P brand evaps very clean, that's what I work with so I tested it out first. The Spice extends life
The Spice expands consciousness
The Spice is vital for space travel
___________________________________________________________________________________________________
Never underestimate the power of STUFF!
I am certifiably insane, as such all posts written by me should be regarded as utter nonsense or attempts to get attention.
I don't know SWIM and personally don't trust him at all. If SWIM is posting, most likely I will not respond...as I said, I don't trust the guy. YOU I trust, but never SWIM.
|
|
|
acolon_5 wrote:Big Inhale wrote:acolon_5 wrote:I always have heard that ronsonal evaps dirty. Beacuse of that I've never bothered with it, plus it's a bit expensive compared to hardware store naphtha.
Has someone evaped a decent amount of it (500mL or so) to see what kind of residue it leaves behind? it is dirty very yellow spice. Needs at least one recrystalisation needed in different solvent. I was refering to just the ronsonal. If you evap it straight from the can you will end up with a nasty residue...at least this is what I've heard. Possible rust retardents or other nasties could be lurking in there....again, I've only read this online and have not performed my own tests on it. VM&P brand evaps very clean, that's what I work with so I tested it out first. I was also referring to Ronsonol. I have also seen spice pulled with Ronsonol very nasty looking almost like bright yellow earwax. Nothing like naptha pulled spice. Can you Imagine? From one single Idea everything appeared here.
RZA
Here in the Prime Creators universe all things are possible,because all things are possible many lessons are learned.
None Of This Is Real!
|
|
|
I have evaporated ronsonal lighter fluid on its own and I didn't see any residue. In fact I put a few drops of lighter fluid on a plate and beside it I put a few drops of tap water. I ended up with more residue from the water. I also use exactly the same lye crystals as Impeccable does, even bought from the same store he mentioned. I put equal parts lye and MHRB into the appropriate amount of water depending on the size of extraction. I let it sit for an our. Then I add some ronsonal. I have an Erlenmeyer flask, so I add enough so I can see enough solvent at the top of the flask for easy extracting. I heat up the ronsonal and add it up to 6 times then combine all the pulls into one container then straight into the freezer. By morning I have 1g based on 200g MRHB. It really is fool proof if you have good bark. Give the spice a little smile... and cross the veil in style.
|
|
|
I didn`t read anything but the first post, but I have only used it and only gotten GREAT results Cheers Q21Q21's Tek: A comprehensive guide to extracting DMTThe 2 teks use non-toxic lime and vinegar and Tek 1: d-Limonene or Xylene or Tek 2: Naptha to produce very quick high yields with the greatest of ease.I am almost never on this site anymore so I will likely not answer PMs
|
|
|
You are right my friend.. i have tested both Ronson and Zippo brand fluids... ronson doesnt absorb much and as i noticed when freeze precipitation not applied it leaves a more dirty product than Zippo brand...
|
|
|
It has always worked great for me if freeze percipt. It will not grow xtals however so it is worthless for cleaning spice ie re xtal. I can produce some fairly clean spice by evaporation if you have the patience for a slow evap. Just make sure you watch it and when the solvent is almost completely evaporated and spice has formed in container tilt the container so the last bit of thick oily solvent runs AWAY for your spice deposits. Then allow to fully dry. If it is all you can get you can then allow to fully dry and wash again with Clean ice cold solvent. Its not the best but for me will work I have gotten some pretty clean spice with it of course it requires a modified tech but works for me. You dont need lots of it either you do your pull then freeze percipt to remove the spice. Then warm or heat and REUSE the same solvent freeze percipt and repete... This can be done a number of time and works great for small extractions up to a kilo or so. I would assume it most likely varies in purity depending when were ect.. you get it after all it is lighter fluid. Naptha is stinkier but better PEACE MV
|
|
|
Big Inhale wrote:acolon_5 wrote:I always have heard that ronsonal evaps dirty. Beacuse of that I've never bothered with it, plus it's a bit expensive compared to hardware store naphtha.
Has someone evaped a decent amount of it (500mL or so) to see what kind of residue it leaves behind? it is dirty very yellow spice. Needs at least one recrystalisation needed in different solvent. Ronsonal also contains heptane, if im not mistaken is hetpane not responcible for pulling lots of jungle spice and fats? this could explain the "dirtier" spice mentioned earlier, and wow, reviving an old thread  just my thoughts
|
|
|
closet-chemist1010 wrote:
Ronsonal also contains heptane, if im not mistaken is hetpane not responcible for pulling lots of jungle spice and fats?
this could explain the "dirtier" spice mentioned earlier,
You're thinking of xylene. Heptane is very selective for white spice.
|
|
|
I have used ronsonol both as my main naptha for extraction and again for re-xtal, the spice after freeze-precip is somewhat yellow but not too much. After re-xtal with fresh ronsonol it's pure white. Oh and I must agree putting FULL LAB in the thread title is misleading. जय गुरुदेव ॐ
|
|
|
If the bark proves to blow buy your bark off celestialsource.com i did a 100g extraction and ended up with 143mg off the first 2 pulls with no re-xtal amazing stuff try it out!!
|